Box Fill Calculator for Oregon
NEC 2023 box fill math for EV charger installers working in Oregon.
Every EVSE installation in Oregon eventually hits a junction or device box — disconnects, splice points, pull boxes — all of which must satisfy NEC 2023 Article 314.16 fill rules.
Worked example for Oregon
A 4-11/16" square × 2-1/8" deep box has a 42.0 in³ volume. Each #6 Cu conductor counts as 5.0 in³. With a 2-conductor + EGC EVSE branch landing in the box plus a device, you consume roughly 15-20 in³, leaving plenty of headroom — but a 60 A multi-port pull box can fill quickly with #4 or #2 AWG conductors.
Code & Utilities
The applicable code in Oregon is the NEC 2023, which the state adopted in 2024. That includes Article 625 (Electric Vehicle Power Transfer System) requirements: 125% continuous-load sizing on EVSE branch circuits, GFCI protection at outdoor receptacles, and provisions for energy management systems on shared circuits.
In Oregon, you'll most often interconnect with Portland General Electric, Pacific Power, Eugene Water & Electric Board. Each has its own service-upgrade timeline, EV rebate availability, and metering rules — confirm them before quoting commercial work.
Climate & Ampacity
Oregon's representative summer design ambient is around 88°F, which yields a 0.88× ampacity correction factor at 75°C terminations per NEC 310.15(B)(1). Because the correction is below 0.9, conductors that "look fine" on a 30°C ampacity table will not carry their nameplate current here — always derate explicitly.
Oregon takeaway
Always run box-fill math when the EVSE disconnect lives more than a few inches from the unit itself — that intermediate junction is where Oregon inspectors most often catch fill violations.