Panel Load Calculation Calculator for Arkansas
NEC 2020 panel load calculation math for EV charger installers working in Arkansas.
Adding EV chargers to an existing Arkansas service triggers an NEC 220 load calculation under 2020. The good news: NEC 220.83 and 220.87 both allow you to use the existing service's measured demand, but the EV load enters at 100% of its 125%-sized branch.
Worked example for Arkansas
On a typical 200 A single-family or small-commercial service in Arkansas, the existing demand plus a new 48 A Level 2 charger (60 A continuous-rated branch) fits comfortably under the service rating in most cases. When you add a second EVSE or a 19.2 kW charger, you usually need either a service upgrade or an NEC 625.42 energy-management system.
Code & Utilities
Arkansas currently enforces the NEC 2020 edition, adopted in 2022. That includes Article 625 (Electric Vehicle Power Transfer System) requirements: 125% continuous-load sizing on EVSE branch circuits, GFCI protection at outdoor receptacles, and provisions for energy management systems on shared circuits.
Major electric utilities serving Arkansas include Entergy Arkansas, Southwestern Electric Power, Arkansas Electric Cooperatives. Always verify the applicable tariff and any utility-specific requirements (CT cabinets, metering enclosures, demand limiters) at design time.
Climate & Ampacity
Plan EV feeders against a 96°F ambient in Arkansas — the resulting NEC 310.15(B) correction of 0.82× is what trims a #6 THWN-2 down to its true continuous rating. Because the correction is below 0.9, conductors that "look fine" on a 30°C ampacity table will not carry their nameplate current here — always derate explicitly.
Arkansas takeaway
Entergy Arkansas's service-upgrade timeline is the long-pole item here in Arkansas — running the panel-load math early lets you decide between an EMS-managed shared circuit and a full upgrade before you're past the point of no return.