Panel Load Calculation Calculator for Wyoming
NEC 2017 panel load calculation math for EV charger installers working in Wyoming.
Adding EV chargers to an existing Wyoming service triggers an NEC 220 load calculation under 2017. The good news: NEC 220.83 and 220.87 both allow you to use the existing service's measured demand, but the EV load enters at 100% of its 125%-sized branch.
Worked example for Wyoming
On a typical 200 A single-family or small-commercial service in Wyoming, the existing demand plus a new 48 A Level 2 charger (60 A continuous-rated branch) fits comfortably under the service rating in most cases. When you add a second EVSE or a 19.2 kW charger, you usually need either a service upgrade or an NEC 625.42 energy-management system.
Code & Utilities
The applicable code in Wyoming is the NEC 2017, which the state adopted in 2020. That includes Article 625 EVSE rules and the 125% continuous-load factor on charging branch circuits, though some 2020-cycle changes (like expanded EMS provisions) are not yet enforced statewide.
Major electric utilities serving Wyoming include Rocky Mountain Power, Black Hills Energy, Wyoming Rural Electric Cooperatives. Always verify the applicable tariff and any utility-specific requirements (CT cabinets, metering enclosures, demand limiters) at design time.
Climate & Ampacity
Wyoming's representative summer design ambient is around 90°F, which yields a 0.88× ampacity correction factor at 75°C terminations per NEC 310.15(B)(1). Because the correction is below 0.9, conductors that "look fine" on a 30°C ampacity table will not carry their nameplate current here — always derate explicitly.
Wyoming takeaway
Rocky Mountain Power's service-upgrade timeline is the long-pole item here in Wyoming — running the panel-load math early lets you decide between an EMS-managed shared circuit and a full upgrade before you're past the point of no return.