Panel Load Calculation Calculator for Ohio
NEC 2017 panel load calculation math for EV charger installers working in Ohio.
Adding EV chargers to an existing Ohio service triggers an NEC 220 load calculation under 2017. The good news: NEC 220.83 and 220.87 both allow you to use the existing service's measured demand, but the EV load enters at 100% of its 125%-sized branch.
Worked example for Ohio
On a typical 320 A single-family or small-commercial service in Ohio, the existing demand plus a new 48 A Level 2 charger (60 A continuous-rated branch) fits comfortably under the service rating in most cases. When you add a second EVSE or a 19.2 kW charger, you usually need either a service upgrade or an NEC 625.42 energy-management system.
Code & Utilities
Ohio currently enforces the NEC 2017 edition, adopted in 2020. That includes Article 625 EVSE rules and the 125% continuous-load factor on charging branch circuits, though some 2020-cycle changes (like expanded EMS provisions) are not yet enforced statewide.
Ohio's primary EV-relevant utilities are AEP Ohio, Duke Energy Ohio, FirstEnergy, DP&L. Each has its own service-upgrade timeline, EV rebate availability, and metering rules — confirm them before quoting commercial work.
Climate & Ampacity
Ohio's representative summer design ambient is around 89°F, which yields a 0.88× ampacity correction factor at 75°C terminations per NEC 310.15(B)(1). Because the correction is below 0.9, conductors that "look fine" on a 30°C ampacity table will not carry their nameplate current here — always derate explicitly.
Ohio takeaway
AEP Ohio's service-upgrade timeline is the long-pole item here in Ohio — running the panel-load math early lets you decide between an EMS-managed shared circuit and a full upgrade before you're past the point of no return.